Command map

request peer refresh

Ask a peer to re-send all routes (RFC 2918).

Ze command

Registry path
request peer refresh
Usage
request peer <selector> refresh
Mode
Daemon
Wire method
ze-bgp:peer-refresh
Backends
any backend
Task support
optional: the MCP call is synchronous, which is the default
Subcommands
none: this command takes no subcommand
Pipes, always
json, ndjson, table, text, yaml, raw, no-more, save
Pipes, when the answer has rows
match, count, first, last, display, fill
Pipes, while streaming
log
Pipes, local process only
save

Description

Sends a ROUTE-REFRESH message for the specified AFI/SAFI. The
peer will re-advertise its entire Adj-RIB-Out.

Arguments

NameTypeRequiredValuesSummaryDescription
selectorstringyesany value of this typeAn address or peer name; * or a pattern for refresh, borr, eorr and flushThe value is an IP address, a peer name, an AS pattern such as as65001, a glob, or * for every peer. 'refresh', 'borr', 'eorr' and 'flush' act on every peer it matches. 'teardown', 'notify', 'disable', 'enable', 'pause', 'resume' and 'clear soft' act on one session: they refuse *, an exclusion such as !edge1, and a selector that matches more than one peer, and they accept a pattern or glob that matches exactly one peer.

Mapping intents

Refresh BGP routes without a hard reset

Category: BGP

Juniper Junos MX

Refresh BGP routes without a hard reset

clear bgp neighbor <peer> soft-inbound verified source: clear bgp neighbor

Cisco IOS XR

Refresh BGP routes without a hard reset

clear bgp ipv4 unicast <peer> soft in verified source: BGP commands

Nokia SR OS

No equivalent is listed for this vendor yet.

VyOS

Refresh BGP routes without a hard reset

reset bgp <peer> soft in verified source: Command Line Interface